Description
If you’re rebuilding a stock engine or planning modest performance gains, S&S Cycle’s Non-Roller Rocker Arms deliver the durability and reliability you need without the complexity of needle bearings. The forged 8620 steel construction provides significantly greater strength than cast alternatives, while the extended .750″ bushings eliminate a common failure point that can cause catastrophic engine damage. This is a straightforward, proven upgrade that gets the job done right.
- Material: Forged 8620 steel
- Rocker shaft bushings: .750″ long
- Bushing load area: 50% increase
- Valve tip: Induction hardened
- Maximum cam lift: .585″
- Fitment: Harley-Davidson compatible
- Installation: Bolt-on replacement
- Set contents: Two front, two rear
- Origin: Made in U.S.A.
- MPN: 900-4119A
