Description
Complete 3 Horse Power Impeller, Seal, Bearing, Silicon & Seal Installation Tool Kit designed specifically for 56 Frame Pump Wet Ends produced by Intertek LX Brand exclusively. Compatible with pumps displaying part numbers WUA-300, WP-300 or LP-300 on their identification label. Please review NOTES below for proper fitment… Video instructions included demonstrate proper installation procedures and verification of correct part selection.
Dimensions: Approximately 4 13/64″ measured across face edge to edge, roughly 3″ from front tip to back sleeve tip, with 7/16″ measurement from inside vane edge to edge. Certain impellers feature identification number B351-21 stamped on surface. If yours displays this marking, you must verify the overall impeller width measurement for accurate part selection. Manufacturing process involves casting a single impeller with this number, then precision-trimming to match various horse power specifications, making edge-to-edge measurement verification essential. Bearing component fits the motor shaft for this pump assembly.
IMPORTANT NOTE: This Wet End housing shares visual similarities with Aqua-Flo and CMP models but is not interchangeable. Confirm your pump brand before ordering.
